Steps On How To Do Plumbing Right

Many of us have no idea how plumbing works. Knowing a few simple tips and tricks can help you keep your money in your hands and not that of a plumber. Sometimes, it is necessary to call up a plumber, but by following a few words of advice, you can take preemptive action and stop a problem before it starts.

Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.

Make sure you know where your home’s water shutoff is located. You never know when there might be an emergency involving a broken pipe or damaged connection that requires you to turn off the water right away. In addition, knowing where the shutoff is located is vital before you start any plumbing project, in case anything goes wrong.

Make sure that the temperature of your home’s water heater is not above 120F. On older water heaters, be sure it is not above medium settings. When temperatures get higher than 120, scalding can occur. Also, having the settings above 120F, tends to use more energy than lower temperatures do.

Use strainers in all drains to catch hair and other objects. This will prevent all the material from going down the drain and causing a clog, which can cause a bigger problem down the line. Clean out the strainers daily so that you don’t start getting backup of water in your sink or tub.

Before embarking on a plumbing project, make sure that you’re aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you’ll be able to stop the water flow.

Mold growing at the base of your toilet can indicate that condensation is forming on your toilet bowl thanks to room temperature versus bowl and water temperature, or that you have a leak in the wax seal around your toilet. To replace the wax seal, turn off the water to the toilet, disconnect from the water supply and then lift the toilet and replace the ring. The real trick is setting the toilet back down on the ring correctly. Buy an extra ring in case you mess up and to avoid having to run to the hardware store in the middle of the job.

Make sure that any exposed pipes in your home are insulated, especially those found in crawl spaces on the outside walls of your home. This will help keep them from freezing and causing you tons of problems. Frozen pipes can often be devastating and leave you with problems that are expensive to fix and no water in the middle of winter.

Hopefully this article helped you learn a little bit more about your plumbing and how to stop issues before they start. By learning and knowing, like was discussed in this article, you can be sure to save a few dollars every year. Plumbing disasters can cost a lot of money, so use this advice well!